You can access your TiltAudio! board by going to the following address while connected to the same wireless network. Please change “ipaddress” to the actual ipaddress of your TiltAudio! board. You can get this by either looking at your home router and seeing what DHCP address it was given, or you can look at the OLED on the board itself. http://ipaddress:31008/

If the OLED display says the ipaddress is 192.168.42.1, that means it is in hotspot mode and it has its own wireless network it is broadcasting. Connect your device to the “TiltAudio” wireless network with the password “tiltaudio” (no quotes), and then you can go to http://192.168.42.1:31008 to config the pi to connect to your home wireless network.

License file. To get a license file, please visit this page: https://go-dmd.de/produkt/10955/